Installing A System Fan - HP ProLiant DL145 Maintenance And Service Manual

Figure 63 Removing a system fan from the chassis

Installing a system fan

1. Install the new system fan:
a. Place the fan in an open fan location in the chassis.
b. Connect the fan power cable to the connector on the system board, and slide the power cable into the
notch in the chassis partition wall.
The fan closest to the power supply connects to P47. The middle fan connects to P48. The fan farthest
from the power supply connects to P49.
c. Tighten the screw holding the fan to the chassis.
Figure 64 Installing a system fan
2. Reinstall the power cable guide above the system fans:
a. Insert the power cable guide into the slots in the rail above the system fans.
b. Slide the power cable guide toward the power supply.
Removal and replacement procedures 53