Instant Light; Power Light; Ready Light; Stay Light - GE NX-1300E User Manual

INSTANT LIGHT

The instant light is "on" when there is no delay on your entry/exit door(s).
Any time the instant light is "on" and the exit delay has expired, the
opening of an entry/exit door will produce an immediate alarm. The
instant light can be toggled on or off by pressing the [Stay] key while the
system is armed. When the instant light is "off", the entry/exit door(s) is
delayed.

POWER LIGHT

The power light is on if the primary power is on. The power light will flash if
the system has a low battery condition.

READY LIGHT

The ready light is "on" when the system is ready to arm and "flashes" if
ready to force arm. The ready light is off when the system is not ready to
arm because of a zone(s) being faulted.

STAY LIGHT

The stay light is "on" when the all interior (motion detector) zones are
bypassed.

ZONE LIGHT

The zone lights are "off" when everything is normal. A zone light will be "on"
if the zone has been bypassed. If a zone light is "flashing", that zone is in
alarm or has been faulted. If a zone light is "flashing" rapidly, it means that
the zone is in a trouble condition.
Tamper
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
"flashing" light for a short period of time, followed by a slow "flashing"
light.)
Hardware
Trouble conditions are:
Low Battery
Page 6
Loss of Supervision