Advertisement
10
INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten
STEM SCREW (3) to secure ADAPTER (1).
Find correct position of LEVER HANDLE ASSEMBLY (4) or CROSS
HANDE ASSEMBLY (5) by adjusting male teeth on ADAPTER (1) to
female teeth in HANDLE (4, 5).
Thread LEVER HANDLE ASSEMBLY (4) or CROSS HANDE ASSEMBLY
(5) onto DECK ADAPTER (6) until snug against mounting surface.
11
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water
lines thoroughly.
Replace AERATOR (3).
12
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (5) and fill Sink with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Sink. If STOPPER (4) does not seal properly, please
refer to "Troubleshooting Guide" in these instructions.
Release POP-UP KNOB (5) down and check all drain
connections and "P" trap for leaks.
if necessary.
TO CLEAN SPRAY
SPRAY (5) may accumulate dirt causing distorted
and reduced water flow. Unscrew and remove
SPRAY (5) and rinse clean.
Replace SPRAY (5) and operate handles several times
from OFF to ON position. Do not force, handles turn only 90˚.
13
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER.DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
SPLINE END DOWN
1
Tighten
HOT
14
SERVICE
To change direction of handle rotation,
proceed as follows
:
Turn valve to OFF position.Unthread HANDLE
BASE (1) from DECK ADAPTER (2).
Pull HANDLE ASSEMBLY off VALVE STEM (3).
Remove SPRING CLIP (4). Lift STOP WASHER (5),
turn 90° and replace. Replace SPRING CLIP (4).
Find correct position of HANDLE ASSEMBLY by
adjusting male teeth on VALVE STEM (3) to
female teeth in HANDLE.
Thread HANDLE ASSEMBLY onto DECK ADAPTER
(2) until snug against mounting surface.
4
4
5
TOP
Figure "A"
4
WASTE
OUTLET
2
THREAD ON
TO DECK
ADAPTER
1
3
2
6
5
1
3
2
COLD
"P" TRAP
HANDLE
ASSEMBLY
UNTHREAD
1
90°
3
5
4
2
M 9 6 8 3 0 1 R e v. 1 . 3
Advertisement
