Advertisement
Quick Links
ENFIELD
DECK-MOUNT BATH FILLER
with
EverClean™ Finish
Congratulations on purchasing your American
Standard faucet with EverClean finish found
only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
IMPORTANT NOTICE TO INSTALLER!
Please check with local Code Authority for the installation requirements of this product. Some codes require an
additional temperature mixing valve to limit the maximum hot water temperature and vacuum breaker
(for products with hand spray) to be installed with this product.
Required Tools
Flat Blade Screwdriver
ROUGHING-IN DIMENSIONS
MOUNTING
SURFACE
8"
Installation
Instructions
2373.900
2373.920
2373.901
2373.921
Adjustable Wrench
LEVER
HANDLE
5-3/16"
3-3/4"
2-7/8"
1-1/8 DIA.
(H)
3/4-14 MALE
1-1/16 DIA.
N.P .T. INLETS
*Supplied with Fitting
Channel Locks
ADJ. 6-1/2 TO 12
2-7/8
DIA.
1-1/4
MAX.
(C)
12 MAX
Certified to comply with ANSI A112.18.1M
M 9 6 8 2 8 8 R e v. 1 . 1
*Wrench
*Hex key
CROSS
HANDLE
8-3/16
2-1/16
2-1/4
DIA.
DIA.
3
1-1/2 MAX.
1-3/16 DIA.
Advertisement
Related Manuals for American Standard Enfield 2373.900
Summary of Contents for American Standard Enfield 2373.900
- Page 1 EverClean™ Finish Congratulations on purchasing your American Standard faucet with EverClean finish found only on American Standard faucets. EverClean Finish • One wipe effortlessly removes spots • Eliminates the need for cleaners and scrubbing • Permanent surface protectant remains beautiful for the life of the faucet •...
- Page 2 SPOUT ASSEMBLY Turn off hot and cold water CAUTION supplies before beginning. Install RING WASHER (1) into SPOUT BASE recess. Check that O-RING (2) on end of SPOUT SHANK (3) is in place. Insert SPOUT SHANK (3) through SPOUT ESCUTCHEON (4) and into center hole on mounting surface.
- Page 3 INSTALL HANDLES Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without a spline is facing up. See figure "A". Tighten STEM SCREW (3) to secure ADAPTER (1). Find correct position of LEVER HANDLE ASSEMBLY (4) or CROSS HANDLE ASSEMBLY (5) by adjusting male teeth on ADAPTER (1) to female teeth in HANDLE (4, 5).
- Page 4 SPOUT (1) is locked in place. EverClean™ Finish Care Instructions American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.