iHome iPL8 Operation Instructions Manual page 10

USI NG T H E UNIT IN OT H E R CO UNT R I E S
Different regions of the world use different FM radio frequency steps and
ranges. You will need to select the one that matches the standards in your
region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is
USA; if you live in the US, you may skip this section.
1. Press and release the
release the Mode Button as needed to cycle to FM radio mode.
Press and hold the Mode Button for about 5 seconds until the region
2.
flashes in the lower part of the display and a beep sounds.
3. Press the + or – Buttons as needed to set the display to your region: USA,
EU (Europe), JPN (Japan), AUS (Australia), or CHN (China).
Press and release the Mode Button (or no button within 10 seconds) to
2.
exit the radio frequency setting mode. Two beeps will confirm radio
frequency setting.
S N O O Z E / D I M M E R O P E R A T I O N
1. To program a custom snooze duration, during normal operation (when
alarm is not sounding) press and hold the Snooze/Dimmer Button until
the display flashes, then press the + and – Buttons on the unit to adjust
the snooze time to 1 - 29 minutes.
2. Press the Snooze/Dimmer Button on the iPL8 after the alarm sounds.
The alarm will be silenced and will come on again in about 9 minutes
(default). You may repeat this cycle several times during the one hour
alarm cycle.
3. During normal operation (when alarm is not sounding), press the
Snooze/Dimmer Button to control the brightness (high, medium, low
and off settings) of the LCD display.
Power Button to turn on the unit, then press and
9