Maintenance; Battery Charge; Battery Replacement; Users Manual - Fluke 572-2 User Manual

572-2

Users Manual

Maintenance

Battery Charge

Use the battery charge symbols to gauge the approximate level of charge left on the
batteries.
When in low battery mode, the Product does not store values.
"Err" shows on the display if attempted.

Battery Replacement

To prevent possible electrical shock, fire, eye damage, and
personal injury:
For safe operation and maintenance of the Product:
The batteries should be replaced in less than one minute after
removal to avoid manually re-initializing the Product clock and
date.
To install or change the two AA batteries (see Figure 8):
1. Slide the locking tab on the battery door to the "" position and then open the
handle.
2. Insert the batteries noting their correct polarity.
3. Close and lock the handle.
16

Shop for Fluke products online at:

Batteries are at 5 %. Before taking further

readings, the batteries must be changed.
Warning
Do not open the Product. The laser beam is dangerous
to eyes. Have the Product repaired only through an
approved technical site.
Have an approved technician repair the Product.
Repair the Product before use if the batteries leak.
Be sure that the battery polarity is correct to prevent
battery leakage.
Caution
Do not short the battery terminals together.
Do not keep cells or batteries in a container where the
terminals can be shorted.
Do not put battery cells and battery packs near heat or
fire. Do not put in sunlight.
MyFlukeStore
www.
Note
Note
.com
1.877.766.5412