Advertisement
Table of Contents
- 1 Split System
- 2 Table of Contents
- 3 What to Do before Operation
- 4 Safety Considerations
- 5 Operation Range
- 6 Installation Site
- 7 Test
- 8 Name and Function of each Switch and Display on the Remote Controller
- 9 Operation Procedure
- 10 Optimum Operation
- 11 Maintenance (for Service Personnel)
- 12 Not Malfunction of the Air Conditioner
- 13 Trouble Shooting
- Download this manual
Advertisement
Table of Contents
Related Manuals for Trane MCW530AMUA0
Summary of Contents for Trane MCW530AMUA0
-
Page 1: Split System
Owner Manual SPLIT SYSTEM High Wall Mounted Type Cooling Only 60Hz Models MCW530AMUA0 MCW536AMUA0... - Page 2 Thank you for purchasing this Trane air condi- tioner. Carefully read this owner manual before using the air conditioner. It will tell you how to use the unit properly and help you if any trouble occurs. After reading the manual, file it away for...
- Page 3 TEST AVAILABLE TEST...
-
Page 4: Table Of Contents
3. OPERATION RANGE ........3 NOTE 4. INSTALLATION SITE ........3 • Contact your Trane dealer in case of changing the 5. NAME AND FUNCTION OF EACH SWITCH combination or setting of group control and two AND DISPLAY ON THE REMOTE remote controller control systems. - Page 5 • After reading, keep this manual at a place CAUTION where any user can read at any time. Further- Do not use the air conditioner for other pur- more, make certain that this owner manual is poses. handed to a new user when he takes over the Do not use the air conditioner for a special appli- operation.
-
Page 6: Operation Range
Execute complete drain piping for perfect d. Where there are considerable voltage fluctua- drainage. tions such as a factory or plant Incomplete piping may result in a water leakage. e. Vehicles and vessels Do not pull on the conduit or hang anything f . -
Page 7: Test
FILTER SIGN RESET BUTTON 5. NAME AND FUNCTION OF EACH Refer to “HOW TO CLEAN THE AIR FILTER”. SWITCH AND DISPLAY ON THE FAN SPEED CONTROL BUTTON REMOTE CONTROLLER Press this button to select the fan speed, HIGH or LOW, of your choice. Refer to figure 1 on page [1] The illustrations in this owner manual correspond to OPERATION MODE SELECTOR BUTTON... - Page 8 Press the AIR FLOW DIRECTION ADJUST but- ON/OFF ton to select the air direction as shown below. Press ON/OFF button The AIR FLOW FLAP display OPERATION lamp lights up or goes off and the sys- swings as shown below and the tem starts or stops OPERATION.
-
Page 9: Optimum Operation
PROGRAM TIMER OPERATION 7. OPTIMUM OPERATION Operate in the following order. Observe the following precautions to ensure the • The timer is operated in the following two ways. system operates. • Programming the stop time ( ) ..The sys- •... -
Page 10: Not Malfunction Of The Air Conditioner
HOW TO CLEAN THE AIR FILTER NOTE • Do not use gasoline, benzene, thinner, polishing Clean the air filter when the display shows “ ” (TIME TO CLEAN AIR FILTER). powder, liquid insecticide. It may cause discolor- ing or warping. Increase the frequency of cleaning if the unit is installed in a room where the air is extremely •... -
Page 11: Trouble Shooting
It is necessary to clean the WARNING inside of the indoor unit. Ask your Trane dealer for When the air conditioner is in abnormal con- details on cleaning the unit. This operation ditions (smell of something burning, etc), requires a qualified service person. - Page 12 II. If the system does not properly operate except for the above mentioned case, and none of the above mentioned malfunctions is evident, investigate the system according to the fol- lowing procedures. 1. If the system does not operate at all. •...
- Page 13 Houston, TX www.trane.com For more information, contact your local district Trane has a policy of continuous product and product data improvement and reserves the right to office or e-mail us at comfort@trane.com change design and specifications without notice. 3VA13886-3A EM02A067...