Cleaning The Air Filters - Trane R410A Owner's Manual

Split system (r410a) 16 seer, inverter units 9,000 to 24,000 btu/hr
Hide thumbs Also See for R410A:
Table of Contents

Advertisement

2.
NOTICE
Never use water with temperature above 45ºC (113ºF) to wash the panel, or it could
cause deformation or discolouration.
3.

Cleaning the air filters

Note: It is recommended to clean the air filters once every three months or more if the unit is
Sharp Coil!
When removing the air filters from the unit, be careful not to touch the coil. Failure to
do so could result in minor to moderate cuts.
1.
2.
MS-SVU29A-EN
Washing
Clean with a soft brush, water and neutral detergent, and then to dry it.
Install front panel
Place two supporters of the front panel into the slots, along the direction of arrows to cover
and clasp the front panel.
located in a dusty location.
CAUTION
Take down the air filter
Open the front panel at an angle, then pull the air filter downward and take it out.
Cleaning
To clean the dust adhering to the filters, you can either use a vacuum cleaner, or wash them
with warm water (the water with the neutral detergent should be below 45ºC/113ºF).
Maintenance
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4mxw64txw6

Table of Contents