Skoda Infotainment Radio Bolero Owner's Manual page 16

WARNING
Please pay attention to the traffic first and foremost! As the driver you are
■
fully responsible for road safety. Only use the system so that you are in full
control of your vehicle in every traffic situation - risk of accident!
Do not use the voice control system in case of emergency, the voice may be
■
distorted in stressful situations. In such circumstances a telephone connec-
tion may not be established or the connection may take too much time to
complete. The emergency number should be dialled manually!
function requirements

First read and observe the introductory information and safety warn-
ings on page 13.
Function requirements for voice control.
The ignition is switched on.

The device is switched on.

No phone call is in progress.

The parking aid is not active.

Requirements for optimum voice command recognition.
›
Only give voice commands when the symbol  is displayed on the device
screen or in the information display.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
Close doors, windows and the sliding roof, in order to prevent external distur-
bances affecting recognition of the voice commands.
›
It is recommended to speak louder at higher speeds, so that the tone of your
voice is louder than the increased surrounding noise.
›
During voice control, limit additional noise in the vehicle, e.g. passengers talking
at the same time.
Note
During voice control, no navigation announcements and traffic announcements
■
are played.
Some voice commands must be spelled out when pronouncing depending on
■
the selected language of communication, such as the Source Selection "SD" card
one.
14
Device operation
Switching on/off

Fig. 9 Multifunction steering wheel

First read and observe the introductory information and safety warn-
ings on page 13.
Switching on voice control
›
Briefly press the button
VOICE
›
By briefly pressing the symbol key 
Activation of voice control is indicated by an acoustic signal and the device screen
will display a collection of basic voice commands for the current menu.
The menu display as well as the acoustic signal can be enabled or disa-
bled » page 22 .
Switching off voice control
›
Press the button on the unit for a long time, or press it twice.
VOICE
›
Hold down or double press the symbol key  on the multifunction steering
wheel.
›
Touch the screen with your fingers (any part of the screen with the exception of
the function key ).
›
Press a button on the unit (with the exception of brief pressing of the button
).
VOICE
›
Utter the voice command Cancel voice control.

on the unit.
on the multifunction steering wheel.
1
