Table of Contents
Advertisement
6. Controller Set Up
6-1. Entering Controller Setup Menu
1. Press the Program (PROG) Switch for more than 2
seconds to display the Program Menu.
2. Move the cursor to the "Controller Set Up" position
by pressing the Up (D) Switch or the Down (C)
Switch, then press the Set Switch to display the fol-
lowing display on the monitor screen.
** Program Menu **
Camera Control *
Receiver Control *
Camera Set Up *
Controller Set Up *
Note: When Mode Selection Switch is selected at
System (SYSTEM) position, Controller Set Up
Menu appears by pressing the Program
(PROG) Switch for more than 2 seconds.
** Controller Set Up **
System *
Communication *
B
Set up Disable
Fig. 17
3. Move the cursor to the "Disable" position by press-
ing the Up (D) Switch or the Down (C) Switch,
then press the Set Switch and "Enable" is dis-
played.
** Controller Set Up **
System *
Communication *
Set up Disable
4. Select the desired item by pressing the Up (D)
Switch or the Down (C) Switch, then press the Set
Switch to select item where the cursor is posi-
tioned.
Press the Program (PROG) Switch to return to the
previous Program Menu as shown in Fig. 1.
To return to the normal camera picture, press the
Program (PROG) Switch again.
-22-
** Controller Set Up **
System *
B
Communication *
Set up Enable
Fig. 18
Advertisement
Table of Contents
