Panasonic WV-Q116 Instructions Manual

WV-Q116E_E.qxd 05.2.2
Instructions
Before attempting to connect or operate this product, please read these instructions completely.
PREFACE
The Panasonic Ceiling Mount Bracket WV-Q116 is provided for the surface mounting of the
Combination Camera WV-CS954 on a suspended (double) ceiling.
PRECAUTIONS
• Before installing the camera, make sure that the
location where the camera is going to be installed
is strong enough to support the entire weight of
the camera (approximately 2.9 kg {6.38 lbs}).
• Mount this bracket in a suspended ceiling having
a minimum of 210 mm {8-9/32"} clearance.
• The ceiling board thickness to mount this brack-
et can be a maximum of 40 mm {1-37/64"} in
thickness.
• Be sure to use the Fall Prevention Wire (provided).
• Be sure to lock the camera with the lock plate,
and make sure that it cannot come off.
• Do not use this bracket with any equipment other
than the WV-CS954.
• Follow all applicable local and national electrical,
fire and safety codes when installing the camera
with this ceiling mount bracket.
INSTLLATION
Be sure to read the "Precautions" before installing the camera.
The model numbers listed in these Instructions have no suffixes attached to them.
11:05 Page 1
Model No.
Inside the ceiling
Fall Prevention Wire
(provided)
Camera Mounting Base
Suspended ceiling
Combination camera
*Refer to the camera's operation manual.
WV-Q116
Ceiling Mount Bracket
Minimum inside ceiling
clearance 210 mm {8-9/32"}
Suspended
ceiling
Maximum 40 mm
{1-37/64"}
Fall Prevention Angle Clip