Table of Contents
Advertisement
5. Camera Set Up
The following functions are only available with the
camera that has set up functions such as the
Panasonic WV-CP610 or WV-BP510 series camera.
1. Press the Program (PROG) Switch for more than 2
seconds to display the Program Menu.
2. Move the cursor to the "Camera Set Up" position
by pressing the Up (D) Switch or the Down (C)
Switch, then press the Set Switch to display the fol-
lowing display on the monitor screen.
** Program Menu **
Camera Control *
Receiver Control *
Camera Set Up *
Controller Set Up *
Fig. 16
3. Select the desired item by pressing the Up (D)
Switch or the Down (C) Switch and then select the
desired mode by pressing the Right (B) Switch or
the Left (A) Switch.
** SET UP **
CAMERA ID
OFF *
ALC/ELC
ALC *
SHUTTER
OFF
AGC
ON
B
SENS UP
OFF
SYNC
INT
WHITE BAL
ATW *
WIDE D-RANGE OFF
MOTION DET
OFF
DNR
OFF
END
SET UP ENABLE
Press the Set Switch to execute the selection or
entering the sub menu.
Notes:
• Refer to the Operating Instructions of the camera
for more details.
• While pressing both the Left (A) Switch and the
Right (B) Switch, press the Set Switch for a few
seconds on the SET UP Menu as shown in Fig.16.
At this time all adjustments and selections are
being changed to the factory default settings.
-21-
Advertisement
Table of Contents
