Dimplex DPH1563 Instruction

Digital Ceramic Heater
DPH1563

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock,
and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materi-
als, such as furniture, pillows, bedding, papers, clothes,
etc. and curtains at least 3 ft. (0.9 m) from the front of the
heater.
3. Extreme caution is necessary when any heater is used
by or near children or invalids and whenever the unit is
left operating and unattended.
4. Always unplug the heater when not in use.
5. Do not operate any unit with a damaged cord or plug, or
if the heater has malfunctioned, or if the heater has been
dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or
mechanical adjustment or repair.
6. Do not use outdoors.
7. The heater is not intended for use in bathrooms, laundry
areas and similar indoor locations. Never locate heater
where it may fall into a bathtub or other water container.
8. Do not run the cord under carpeting. Do not cover cord
with throw rugs, runners or the like. Arrange cord away
from traffic area and where it will not be tripped over.
9. To disconnect the unit, turn the controls off, then remove
the plug from the outlet.
10. Do not insert or allow foreign objects to enter any venti-
lation or exhaust opening as this may cause an electric
shock or fire, or damage to the heater.
11. To prevent a possible fire, do not block air intake or ex-
haust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
12. All electrical heaters have hot and arcing or sparking
parts inside. Do not use in areas where gasoline, paint,
or flammable liquids are used or stored or where the unit
will be exposed to flammable vapours.
13. Do not modify the heater. Use it only as described in
this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to
persons.
14. To reduce the risk of electric shock, this appliance has a
polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Always plug heaters directly into a wall
outlet/receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
15. Always use properly grounded, fused and polarized
outlets.
16. Disconnect all power supply before performing any
cleaning, maintenance or relocation of the unit.
17. When transporting or storing the unit and cord, keep in a
dry place, free from excessive vibration and store so as
to avoid damage.

SAVE THESE INSTRUCTIONS

Operation
Figure 1
F
A
C
D
CAUTION: Ensure that the unit is placed on a firm, level
surface and not located directly below a convience electri-
cal outlet before operation.
!
NOTE: The unit is equipped with a tip over safety switch
where if the unit is not sitting on a level surface, if it is lifted or
tipped, it will turn off.
When the heater is initially plugged in, there will be three
beeps and the red light (G) will come on indicating that there
is power to the unit. The red light will remain lit until the heat-
er is unplugged from the electrical outlet.
Manual Controls
(Figure 1)
The heater can be turned ON by pressing the On/Off button
(A). This will turn the unit on to the last setting it operated in
and the current temperature will be displayed on the screen
(F).
!
NOTE: The temperature scale can be changed by hold-
ing down the "+" button for 8 seconds.
Control Settings
The heater has five different controls settings which can be
cycled through by pressing the MODE selection button (E).
The control settings are:
• ECO - In this setting the user can using the temperature
adjustment buttons (B) to set the desired room tempera-
ture and the unit will control the heater and fan to main-
tain that temperature. The room temperature can be set
between 60 - 90 oF (16 - 32 oC).
To adjust set temperature, Press the button + to increase
the desired temperature and the button - to decrease the
desired temperature.
!
NOTE: When the air temperature reaches the set tem-
perature, the heater will turn off and the fan will run for 25
seconds to cool down. When the air temperature drops 2 de-
grees below the set temperature, the unit will come back on.
• FAN - The fan setting runs just the fan to circulate air
throughout the room.
• ANTI-FREEZE - The heater will run to keep the room at
45 oF (7 oC), to prevent freezing.
!
NOTE: The anti-freeze temperature cannot be adjusted.
• LOW HEAT - In this setting the heater and fan will run at
the minimum power level.
• HIGH HEAT - The heater will operate at maximum power
for rapid heating of a room.
G
E
B
7212890100R07