Figure 3: Rf Receiver Data Cable; Figure 4: Removing The Rf Receiver; Figure 5: Removing The Dc Siren And Icp-Vr8488 Pcb; Figure 6: Entry Holes - Bosch ICP-VR8488 Quick Referenc Manual

ICP-VR8488 | Quick Reference Guide | 3.0
Figure 3: RF Receiver Data Cable
1 – RF Receiver data cable connector
6. Remove the RF Receiver from the case by
pressing the two holding clips away from the RF
Receiver while lifting the RF receiver circuit
board away from the clips. Refer to Figure 4 on
page 7.
Figure 4: Removing the RF Receiver
1 – Holding clips
7. Press down on the latch that holds the siren in
place lift the siren away from the side of the case.
Refer to Figure 5 on page 7.
Bosch Security Systems, Inc. | 12/08 | F01U089640-01
Installation
1
1
Figure 5: Removing the DC Siren and
ICP-VR8488 PCB
1
3 2
1 – Siren latch
2 – ICP-VR8488 PCB latch
3 – DC siren
8. Press the latch away from the ICP-VR8488 PCB
and remove the PCB from the case.
9. Insert the telephone lead through the entry hole
shown in Figure 6 on page 7 and route the
telephone lead as shown in Figure 7 on page 8.
Figure 6: Entry Holes
1
1 – Telephone lead entry hole
2 – AC plug pack lead entry hole
EN | 7
2