ICP-VR8488 | Quick Reference Guide | 1.0
1.0 Product Contents
The Bosch Security Systems, Inc. (Bosch)
ICP-VR8488 Intruder Alarm System includes:
ICP-VR8488 unit (includes case, keypad,
ICP-VR8488 printed circuit board, 433MHz RF
Receiver (RF3213E)
2.0 Introduction
The ICP-VR8488 is a desktop alarm system that
incorporates keyfobs and supervised wireless sensors.
You can assign up to 16 separate wireless devices to
any of the eight available zones.
2.1
Features
•
Eight zones
•
Eight User Codes
•
Eight RF keyfobs
•
Supervised battery
•
Desktop or wall-mountable
•
Up to sixteen supervised wireless sensors
•
Telephone line monitor
•
Access denied supervision
•
Lockout dialer and siren
•
AWAY Mode and STAY Mode operations
•
Delay reporting
•
Day Alarm
•
Telephone arming (AWAY Mode)
•
Answering machine bypass
•
Event memory recall
•
Upload and download programmable
•
Entry and Exit Warning
•
Dual Reporting
•
Sensor Watch
•
Automatic Arming and Disarming
•
AC Fail and Trouble Indicators
•
Walk Test Mode
•
Automatic Call Forward On and Off
3.0 Installation
1. At the rear of the ICP-VR8488, insert a flat
bladed screwdriver into the slot between the base
and top cover as shown in Figure 1 on page 6.
Bosch Security Systems, Inc. | 12/08 | F01U089640-01
Product Contents
Figure 1:
2. Use the screwdriver to pry the top cover up and
forward.
3. Remove the top cover from the base unit as
shown in Figure 2 on page 6. Note that the
keypad and the ICP-VR8488 printed circuit
board (PCB) are connected.
Figure 2:
1 – Keypad data cable connector
4. Disconnect the data cable at the keypad
connector.
5. Unplug the RF receiver data cable as shown in
Figure 3 on page 7.
Opening the Cover
Removing the Cover
EN | 6