Sharp GZ200 User Manual page 87

• To specify the types of notes or rests, see page 88.
8.
When you finish inputting, press [Options] and
select "Save".
9.
Select "Save to Gallery".
Note
• The volume varies depending on the Ringer Volume
settings (p. 92). The sound is deactivated when
"Ringer Volume" is set to "Silent".
• If the capacity or memory in Saved Sounds becomes
insufficient, the message, "Maximum capacity : 250
Not registered." or "Not registered. Memory full." is
displayed. The screen returns to step 9. Try again
after deleting unnecessary data.
• Melodies consisting of too many short notes
(semiquavers and triplets) cannot be played back in
step 8 and the following message is displayed: "Can
not play due to too many notes per sec." The screen
returns to step 5.
The message "Can not save due to too many notes
per sec." may also be displayed, and the screen
returns to step 5.
Reduce the number of melodies, replace short notes,
cancel triplets, etc. to remedy.
To Specify the Musical Scale and Rest
Using the keys shown below, specify the musical scale
and rest.
Do Re Mi Fa
G H I J K L M Q
When you press the key shown above once, a crotchet
is specified in the middle scale (no mark).
When you press the same key repeatedly, the note will
shift cycle through the available octave ranges.
L
When you press a or b whilst a note is selected, the
note will move one semitone higher or lower.
When entering rest, crotchet rest is entered.
Sol La Ti
L L
L
Organiser
Rest
87