Transmitter Audio Gain Adjustment - Shure T series Manual

4. Press the attached WL93 lavalier microphone into the mounting clip and attach
it to your garment. Do not cover the microphone with your clothing, and keep it
approximately 8 to 12 inches below your chin. See Figure 9.
5. Slide the recessed transmitter POWER ON/OFF switch to the ON position. The
green transmitter POWER ON light will glow. The yellow RF light (T3) or DIVERSI-
TY A/B lights (T4V) will also glow.
6. Slide the recessed transmitter MUTE/ON switch to the ON position to unmute the
system.
7. Speak in your normal conversational voice. Proper operation is indicated by:
Steady glow of the yellow RF light (T3) or DIVERSITY A/B lights (T4V).
Flickering of the red PEAK light ( T3) or AUDIO PEAK light (T4V) when you
speak in a loud voice.
NOTE: If the red PEAK light on the receiver does not flicker occasionally, the
transmitter gain may need to be increased. Refer to the Transmitter Audio Gain
Adjustment paragraph. Then, If the system is still not operating properly, consult
the Troubleshooting table.
8. When the presentation is over, slide the recessed transmitter POWER ON/OFF
switch to the OFF position to conserve battery power.

TRANSMITTER AUDIO GAIN ADJUSTMENT

The audio gain control on the T1G Transmitter is factory-preset at the minimum set-
ting (full counterclockwise) to reduce the risk of overload and resulting distortion and/
or clipping. If the red PEAK light on the receiver does not flicker when the guitar is
played loudly, you should adjust the transmitter gain level so that it matches the out-
put level of your guitar or bass. This will ensure the best possible signal-to-noise ratio
during performance. Refer to Figure 12.
The gain control on the T1, T11 and T2 transmitters has been factory preset at the mid-
range position for best performance in most applications. However, for singers or talkers
with soft, quiet voices, the preset gain level may be too low and the audio gain may need
to be increased for best signal-to-noise ratio. This condition is indicated by the failure of
the receiver PEAK light to flicker when you speak in your normal voice.
For loud singers or talkers, the preset gain level may be too high, causing unwanted
distortion. This condition is indicated by the continuous glow of the red PEAK light on
the receiver when you sing or speak in a loud voice.
T2
To Increase Gain: Rotate the transmitter gain control clockwise with the supplied
screwdriver until the red PEAK light on the receiver flickers when the guitar is
played loudly, or when you sing or speak in a loud voice..
T1/T1G
FIGURE 12
13
T11
ENGLISH