Transmitter Battery Installation - Shure T series Manual

ENGLISH

TRANSMITTER BATTERY INSTALLATION

1. Slide the transmitter POWER ON/OFF switch to the OFF position.
2. T1 : Press down on the OPEN side of the battery compartment cover, slide it back
and flip it open, as shown in Figure 6A.
3. T2: Unscrew the transmitter battery cover to expose the battery terminals, as
shown in Figure 6B.
A
B
4. Insert a fresh 9V alkaline battery into the battery compartment (Duracell MN1604
recommended and included with the system). A fresh 9V alkaline battery should
typically provide 18 hours of performance time. A fully charged 8.4V NiCad bat-
tery should provide 2 hours of performance time. When the red LOW BATTERY
light on the transmitter glows, you have 1 hour or less of useful battery life remain-
ing; change the battery at your first opportunity.
IMPORTANT: Carbon-zinc and zinc-chloride batteries will not provide adequate
power and are not recommended.
5. Replace the battery cover.
OPERATING THE GUITARIST SYSTEM
1. Attach the transmitter to your belt or guitar strap as shown in Figure 7.Depress
the tab marked PRESS and slip the belt or strap between the transmitter body and
the belt clip. The clip holds tighter if the material is drawn to the clip's top wire (es-
pecially when using thinner guitar straps).
FIGURE 6
FIGURE 7
8