Advanced Configuration; Ip Settings For Wireless Clients - NETGEAR ProSafe WNDAP350 Reference Manual

This chapter describes how to configure the advanced features of your ProSafe Dual Band
Wireless N Access Point WNDAP350 . The advanced configuration features are located under
various sub-menus under Configuration and provide the following functions:
• IP Settings. Using the wireless access point as a DHCP server for wireless clients
Settings for Wireless
• Hotspot settings. Enabling HTTP redirect
• Wireless Settings: Configuring advanced wireless LAN parameters
Wireless Settings).
• Advanced QoS Settings: Configuring advanced QoS settings
Settings)
• Access Point Settings: Enabling wireless bridge modes

IP Settings for Wireless Clients

You can turn the WNDAP350 into a DHCP Server for wireless clients for both DHCP-enabled
wireless clients. The default advanced IP wireless settings usually work well. This feature is
intended for use by a systems administrator. By default, this feature is not enabled.
To use this wireless access point as a DHCP server:
1. From the main menu under Configuration, select IP, and then select DHCP Server Settings.
The DHCP Server Settings screen displays (see
2. DHCP Server is disabled by default. Select the Enable radio button to enable this wireless
access point as a DHCP server.
Clients).
("Hotspot
v2.0, April 2013

Advanced Configuration

Settings).
("Configuring Advanced QoS
("Enabling Wireless
Figure 4-1).
Chapter 4
("IP
("Configuring Advanced
Bridging).
4-1