Panasonic WJ-ND200 Operating Instructions Manual page 63

Symptom
Some contents are not dis-
played on the browser.
The image is not being
refreshed.
Cannot record images.
Live/recorded images in
MPEG-4 format are not dis-
played in a normal manner.
No SD memory data is dis-
played in the recording
event list.
Cannot play SD memory
data.
Cause/solution
• Reload the contents by pressing the [F5] key.
• Depending on the traffic of the network, there might
be difficulties in displaying images. Press the [F5] but-
ton on the keyboard to request images.
• Images recorded at low recording rate (less than 1
ips) may sometimes not be refreshed.
• Is the HDD inserted correctly and firmly?
• Is the HDD formatted correctly?
• Isn't the write protection of the HDD set to "ON"?
• Check the current information of the HDD. The disk
information can be check on the "Disk Information"
page ("Maintenance" – "Disk Information").
• Is the HDD removed from the unit before?
Once the HDD is removed from the unit, it is neces-
sary to format the HDD again to record images on it.
• When turning on the power of this unit or when con-
necting the LAN cable to the network port when the
camera is active, images may not be displayed/
recorded in a normal manner for around a minute (at
a maximum) just after turning on the power of this unit
or after connecting the LAN cable to the network port.
• It is impossible to play SD memory data from the
recording event list or time and date search result.
After filtering by "SD memory" in the recording event
list, select an event to play it.
• The recording time of SD memory data will be dis-
played based on the clock of the camera. Check the
clock of the camera.
• When the SD memory data contains not many
frames, playback sometimes may not be performed in
a normal manner.
In this case, display the image with frame playback/
reverse frame playback.
Reference
pages
–
–
–
13
14
Refer to the
setup instruc-
tions (PDF).
–
–
–
–
63