Charging Your Device - Brookstone iConvert Scanner V2 User Manual

caRe anD MaInTenance
CLeANINg tHe LeNS
1 . Power off the Scanner and remove
your device .
2 . Hold the handle of the LENS CLEANER .
3 . Insert the LENS CLEANER, with the
fabric side facing UP, all the way into
the EXIT SLOT of the Scanner .
4 . Slide the LENS CLEANER back and
forth, all the way to either end of the
EXIT SLOT, to clean the lens . Repeat a
few times .

chaRGInG YoUR DevIce

1 . Power off the Scanner before docking your device .
2 . With the Scanner powered off, but still connected to a power source,
dock your device to the 30-PIN CONNECTOR .
3 . Your device will indicate the status of its charge .
Note: If your device is not charging, make sure the Scanner is
powered off, remove your device and then re-dock.
13
(conTInUeD)