Audiovox VME9020TS Manual & Warranty page 7

3. Place the radio in front of the dashboard opening so the wiring can be brought
through the mounting sleeve. Follow the wiring diagram carefully and make certain all
connections are secure and insulated with wire nuts or electrical tape. After completing
the wiring connections, plug the ISO connectors into the mating sockets on the rear of
the chassis. Turn the unit on to confirm operation (vehicle ignition switch must be "on").
If the unit does not operate, re-check all wiring until the problem is corrected.
4. Mount the new radio assembly to the dashboard or center console using the rever-
se procedure in step 1.
CAUTION: For proper operation of the CD player, the chassis must be
mounted within 30° of horizontal. Make sure the unit is mounted wit-
hin this limitation.
NOTE: It is the end-users responsibility to install and operate this unit
in a manner in accordance with local, state and federal laws. The
PARKING BRAKE wire MUST BE CONNECTED as directed in the manu-
al.
CAUTION: Do not block the cooling fan exit. If blocked, the unit may
overheat and become damaged.
Using the iAUX3 External AV Connector
The iAUX3 allows you to connect a variety of external devices, including a VCR, DVD
player, portable MP3 player, etc., to your VME9020TS without removing the radio.
To install the iAUX3, connect it to the AUX-IN cables on the back of the VME9020TS
(see "Wiring" on page 9), and then install the iAUX3 in a location convenient for plug-
ging in auxiliary devices.
7