Speaker Selection - Audiovox VME9020TS Manual & Warranty

SURR SETUP Menu
To change speaker settings for 2-channel mode, use the
the remote control or the
To change speaker settings for 6-channel mode, select "Full 6CH". After selecting 2 or
6-channel mode, use the
stick (17) to move to the speaker settings on the right.

Speaker Selection

Selecting LARGE for the multi-channel speaker option will give a full range output.
Selecting SMALL for the multichannel speaker option will activate a high pass filter
whose crossover is dependent upon the sub-woofer low pass filter frequency. For exam-
ple, if the subwoofer low pass filter is set to 80Hz, then the high pass SMALL speaker
crossover will be 90Hz.
Low pass
80Hz
120Hz
160Hz
Refer to page 56 when selecting speaker options for each mode.
or buttons (6, 7) on the joystick to select "DownMix".
button (19) on remote control or the button on the joy-
High pass
90Hz
135Hz
180Hz
55
or II buttons (14, 22) on
SUBJECT TO TECHNICAL CHANGE