Audiovox VME9020TS Manual & Warranty page 32

Setting Options
Bass Center
60Hz
Freq
80 Hz
100Hz
130Hz
150Hz
200Hz
10KHz
Treble Center
Freq
12.5KHz
15KHz
17KHz
Sub.W Filter
80Hz
120Hz
160Hz
OD
Sub.W Phase
180D
Bass Q-Factor
1.0
1.25
1.5
2.0
BACK
Exiting the System Setup Menu
To exit setup mode and resume normal playback, press the SYS SETUP button (31) on
the remote control or the DISP button (13) on the front panel.
Table 7: ASP Config Menu Features
Function
According to the audio source, select the Bass Center
Frequency to achieve the best Bass effect.
According to the audio source, select the Bass Center
Frequency to achieve the best Treble effect.
Selecting a crossover frequency sets a cut-off frequency
of the subwoofer´s LPF (low-pass filter) and the "SMALL"
speakers`HPF (high-pass filter). The Crossover frequency
setting has no effect if the subwoofer is set to "OFF" and
any other speaker is set to "LARGE".
Subwoofer output IN phase
Subwoofer output OUT OF phase
Note: Depending on your installation, reversing the sub-
woofer phase may increase Bass output.
When the Bass Center Frequency is selected, adjusting
the Bass Q-Factor alters the sharpness of the Bass out-
put.
Return to previous menu.
32