Table of Contents
Advertisement
SE3401 Asset Tracking Transmitter
Features
Alerts Central Console of Transmitter's ID and location immediately on alarm.
Available post-alarm tracking, alarm map recall, and more.
Internal antenna.
Two-year battery life.
Can be mounted virtually anywhere on virtually anything.
Low battery indication at Central Console.
Includes mounting plate.
Description
The SE3401 Point Tracking Transmitter contains a unique code which is associated with an asset at the time the
Transmitter is assigned. When an alarm is generated, this code is sent to the Central Console, which graphically
displays the asset's location on a map along with a picture of the asset and any other necessary information.
Installation
The SE3401 can be configured to monitor magnetic or dry external contacts. When mounted with an external
magnet, the SE3401 is mounted on the asset and the magnet is mounted on an opposite surface (such as a wall).
When mounted with external contacts, the SE3401 can be mounted anywhere on the asset and connects to the
contact by two wires connected to the terminals inside the Transmitter and an end-of-line resistor.
Transmitting an Alarm
Depending on the installed options, when an alarm is generated within approximately two seconds, the sounders in
any nearby Receivers could be activated as well as the Strobes and Sirens connected to nearby Alert Units. The
alarm signal is transmitted to the Receivers which in turn relay the alarm signal to the Transponder and along to the
Central Console. The Central Console graphically displays the Transmitter's location along with the asset's
description and a picture of the asset. Also, once an alarm is initiated, the Transmitter commences its Auto-Tracking
feature.
Auto Tracking Feature
Once an alarm has been initiated (such as when the Transmitter has been moved away from the magnet) the Auto-
Tracking feature will begin. The Transmitter will send a signal back to the Central Console every few seconds
updating its location for several minutes. To reset the Transmitter after an alarm has been initiated, all device
conditions (e.g., tamper, loop, magnet) must be reset to normal.
Supervision Feature
The SE3401 Point Tracking Transmitter can also be configured to transmit periodically when there is no other activity
to report its status and location to the Central Console.
Low Battery Reporting
When the Transmitter is tested, a special "low battery" message is included in the transmission to the Central
Console if the Transmitter's battery is in need of replacing. These low battery alerts are logged at the Central
Console.
Security Escort Training
Page 13 of 142
Advertisement
Table of Contents
