Table of Contents
Advertisement
Transponder Parameter Change
This dialog allows parameters stored in the transponder's EEPROM memory to be viewed and changed.
"Run Silent"
If checked the receivers and alert units on this transponder will not sound for an alarm. This includes alarms that
are received during a communications failure with the Central Console.
"Optional Parameter"
This is a future option, it should be left unchecked.
"Loop communications"
Normally the transponders are connected in parallel (party line) so they can all hear if any other transponders are
in communications so they don't collide when communicating. However if fiber optic communications is used
between the transponders and PC they can't be connected this way. Therefore they are connected in a loop. The
transmit from the PC goes to the receive on the first transponder. The transmit from the first transponder goes to
the receive on the second transponder and so on ... Until the transmit from the last transponder goes to the
receive on the PC. This option tells the transponders they are connected this way so it can react. You must make
this change to the first transponder first, then the second, continuing in order until all are done.
"Enable Remote Key"
If checked the remote key supervised input on this transponder is enabled. Otherwise it will be ignored.
"Uses Proxim Radio"
Only check this item if a Proxim radio is used to communicate to the Central Console.
"Comm Fail to Siren Out"
If this item is checked the siren output on this transponder will activate when a communications failure is
detected with the Central Console.
Transponder Parameter Change Dialog
Security Escort Training
Page 119 of 142
Advertisement
Table of Contents
