Solving Setup Problems; Noise After Ink Installation - Epson Stylus NX230 User Manual

3. Load plain paper in the product.
4. Hold down the
5. When the product turns on, release both buttons.
The product begins printing a nozzle check pattern.
6. Do the following, depending on the results of the product check:
• If the page prints and the nozzle check pattern is complete, the product is operating properly. Any
operation problem you may have could be caused by your computer, cable, software, or selected
settings. Check the other solutions in this manual or try uninstalling and reinstalling your printer
software.
• If the page prints but the nozzle check pattern has gaps, clean or align the print head.
• If the page does not print, the product may have a problem. Check the other solutions in this
manual. If they do not work, contact Epson.
Parent topic:
Related concepts
When to Uninstall Your Product Software
Print Head Cleaning
Print Head Alignment
Related references
Where to Get Help

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Noise After Ink Installation

Software Installation Problems
Parent topic:
Noise After Ink Installation
If you hear noises from your product after installing ink, check these explanations:
• The first time you install ink cartridges, the product must prime its print head. Wait until priming
finishes before you turn off the product, or it may prime improperly and use excess ink the next time
you turn it on. Your product is finished priming the print head when the
stop button and press the
Solving Problems
Solving Problems
power button to turn the product on.
149
power light stops flashing.