The G3 Disc Publisher Software; Microboards Printwrite Configuration; The Microboards Printer Toolbox; Print Test Disc - MicroBoards Technology G3 User Manual

The G3 Disc Publisher Software

Your G3 uses Microboards PrintWrite as the Disc Publishing software.
You can print directly from SureThing or other applications if you are only printing, but any
burning must be done using PrintWrite.

Microboards PrintWrite Configuration

The first time you launch PrintWrite, you will be asked to
confirm the configuration of the G3 Disc Publisher
system. This only needs to be done the first time the
software is used, or if there is a change to your hardware.
The Drive, Printer, and COM port will auto-detect your
hardware and enter the information. If the auto-detected
hardware is not correct, use the down arrows in each
listbox to select other available hardware. Use the Test
buttons beside each hardware entry to verify the correct
hardware has been selected.
The Name of the G3 will appear as
This can be changed to any name you wish.
Please refer to the Microboards PrintWrite User's Manual
for more information on configuring and operating
PrintWrite.

The Microboards Printer Toolbox

To access the Microboards Toolbox, double-click the toolbox icon located
in the tool tray.
Select the Microboards G Series
maintenance function of the Toolbox for the selected printer.

Print Test Disc

Load an unprinted disc in the input hopper prior to clicking this button to print a Test Disc image.

Exercise Belt

This utility should be run if the printer has been idle for an extended period of time, and can be run
multiple times if necessary. The belts will run at high speed for a period of time to recondition the
belts. It is not necessary to load any media for this utility.

Cleaning

The printheads may require cleaning if the printed images show streaks of color. This may occur if
the Disc Publisher has been idle for an extended period of time.
You will need to place a disc on the belts below the input hopper prior to running the Cleaning.
Running this process more than once may be required if the quality does not improve after cleaning
one time.
• The Microboards Printer Toolbox
18
Publisher by default.
and click the buttons to access each