Table of Contents
Advertisement
The Control Panel
1
2
3
4
1
1 MEMORY buttons and
corresponding pilot lights
A previously selected wash programme can be
stored or recalled by pressing these buttons.
To store: select the required programme using
the various buttons available (see section
"Operating sequence"), then start the machine
by pressing the START/PAUSE button. Only
then can the programme be stored by pressing
one of the "Memory" buttons until the
corresponding pilot light comes on.
If the "Memory" button pressed does not yet
have a programme stored, the pilot light flashes
for two seconds.
A stored programme can be modified by
pressing the required buttons before starting the
machine with the START/PAUSE button.
To recall a programme: press the required
"Memory" button; the pilot lights corresponding
to the stored programme come on. Press the
START/PAUSE button to start the machine.
Warning! Your machine may already have a
programme stored. This means that it has been
carefully tested before leaving the factory.
Note: It is advisable to make a note of the
programme stored for each "Memory" button.
R
ON - OFF
CANCEL
2
3 4
USE
HOLD
S
5
6
7
2 ON/OFF-CANCEL button
This button has two functions:
- switch the machine on/off
- cancel a programme which is running
Press the button to switch the machine on,
press it again to switch the machine off or to
cancel a programme which is running.
3 FABRICS button
Press this button to select the type of wash
required: White cotton, Synthetic, etc. The pilot
light corresponding to the type of wash selected
comes on and the washing time flashes on the
display (9); times are calculated on the basis of
a maximum load of 5 kg for cotton, 2 kg for
delicates and synthetics and 1 kg for wool.
After about 20 minutes (the time it takes the
machine to calculate the weight of the laundry)
the washing time is updated (only for cottons).
The machine automatically selects the
maximum temperature and spin speed based on
the type of wash selected: the corresponding
pilot lights come on.
These values can be modified by pressing the
TEMPERATURE and SPIN SPEED buttons.
The "Fabrics" button cannot be used when the
FRESHEN UP programme or one of the SPECIAL
PROGRAMMES are selected.
8 9 10 11 12
9
Advertisement
Table of Contents
