Related Manuals for Zanussi FL1001
Summary of Contents for Zanussi FL1001
-
Page 1: Washing Machine
WASHING MACHINE PRALKA AUTOMATYCZNA AUTOMATICKÁ PRAČKA AUTOMATICKÁ PRÁČKA AUTOMATA MOSÓGÉP FL1001-FL 1201 INSTRUCTION BOOKLET INSTRUKCJA OBSLUGI NÁVOD K OBSLUZE NÁVOD NA OBSLUHU HASZNÁLATI ÚTMUTATÓ 132999510... - Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged.
-
Page 3: Table Of Contents
Contents Warnings Maintenance Door seal Disposal Bodywork Detergent dispenser drawer Tips for environmental protection 5 Drain filter Water inlet filter Technical specifications Emergency emptying out Frost precautions Installation Unpacking Something not working? 26-27 Positioning Water inlet Water drainage Electrical connection Your new washing machine Description of the appliance Door locked pilot light... -
Page 4: Warnings
Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Use only the recommended quantities of fabric softener. An excessive amount could damage the • All internal packing must be removed before using laundry. -
Page 5: Disposal
Child safety • Make sure that children or pets do not climb into the drum. • Children are often not aware of how dangerous • When the appliance is to be scrapped, cut off the electrical appliances can be. When the machine is electrical supply cable and destroy the plug with working, children should be carefully supervised the remaining cable. -
Page 6: Technical Specifications
Technical specifications DIMENSIONS Height 85 cm Width 60 cm Depth 60 cm MAXIMUM LOAD Cotton 5.5 kg Synthetics 2.5 kg Delicates 2.5 kg Woollens SPIN SPEED 1000 rpm max. (FL 1001) 1200 rpm max. (FL 1201) POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz TOTAL POWER ABSORBED 2200 W MINIMUM FUSE PROTECTION... -
Page 7: Installation
Installation Unpacking Positioning Install the machine on a flat hard floor. All transit bolts and packing must be removed Make sure that air circulation around the machine is before using the appliance. not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen You are advised to keep all transit devices so that units. -
Page 8: Water Drainage
Water drainage Electrical connection The end of the drain hose can be positioned in three This machine is designed to operate on a 220-230 V, ways: single-phase, 50 Hz supply. Hooked over the edge of a sink using the plastic Check that your domestic electrical installation can hose guide supplied with the machine. -
Page 9: Your New Washing Machine
Your new washing machine This new washing machine, which is fitted with the Jet system, patented Zanussi, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed. -
Page 10: Use
Control panel ON-OFF CANCEL 9 10 1 Function of MEMORY buttons Recall There are 4 Memory buttons at your disposal to A memorized programme can be recalled pressing memorize and recall the four washing programmes the corresponding Memory button. that are used more frequently. •... - Page 11 4 TEMPERATURE button Main switch Pressing this button you can modify the washing Pressing the ON/OFF button the machine is temperature proposed by the machine. switched on and off; the machine can be programmed when three dashes are blinking on the display.
- Page 12 There are 3 possibilities to drain the water: It is used for very soiled laundry. With the wool and “Freshen up” programmes • Choose the “Drain” programme. this function cannot be chosen. The water is drained without spin. • Press only the Start/Pause button. Quick wash The machine drains the water and carries out the With this function the washing cycle of the cotton,...
- Page 13 Freshen up Extra rinse This programme can be used particularly for briefly Attention! This option can be chosen only after used and not very soiled laundry and for laundry selecting the TYPE OF FABRIC. stained with sweat. The machine carries out an additional rinse: 4 It is possible to set a washing temperature of 60°C instead of 3.
- Page 14 After the start, the indication of the remaining time Alarm code decreases by one unit every minute. In case of breakdowns of the appliance, these are Many elements determine the duration of the indicated on the display with a special code, very programme, e.g.
-
Page 15: Delay Start Button
How to open the door Drain 1. With the machine switched off Pressing this button: With power supply switched off (with the machine • the water of the programme “SOAK” is drained, off) it is possible to open the door in any moment. To •... -
Page 16: Washing Hints
Laundry weights Washing hints The following weights are indicative: bathrobe 1200 g Sorting the laundry napkin 100 g Follow the wash code symbols on each garment quilt cover 700 g label and the manufacturer’s washing instructions. Sort the laundry as follows: sheet 500 g whites, coloureds, synthetics, delicates, woollens. -
Page 17: Detergents And Additives
Ink: depending on the type of ink, moisten the fabric Quantity of detergent to be used first with acetone (*), then with acetic acid; treat any The type and quantity of detergent will depend on residual marks on white fabrics with bleach and then the type of fabric, load size, degree of soiling and rinse thoroughly. -
Page 18: International Wash Code Symbols
International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash Max. wash Max. wash temperature temperature temperature temperature 95 C 60 C 40 C 30 C Hand wash... -
Page 19: Operating Sequence
3. Measure out the additive Operating sequence Pour any liquid additives, to soften or starch the laundry, in the compartment Before washing your first load of laundry, we Do not exceed the MAX level. recommend that you run a cotton cycle at 60°C, with the machine empty, to remove any manufacturing residue from the drum and tub. -
Page 20: Start The Machine
6. Choose the temperature 10. Start the machine Press the button until the desired washing Press the START/PAUSE button to start the set temperature illuminates. programme. The display shows the duration of the programme or the selected delay. 7. Choose any options 11. -
Page 21: Altering A Programme
Altering a programme • As long as a washing programme is not started, the different options can be modified without any problems. • If you want to modify a programme in progress, you must press the PAUSE button, afterwards it is possible to carry out a modification of the washing programme. -
Page 22: Washing Programmes
Programme chart WASHING PROGRAMMES Consumption* Available Programmes Fabrics Max. load Energy Water Time options litres h/min. White cotton 95° White cotton, e.g. working clothes PREWASH normally soiled, bed linen, table linen QUICK WASH and underwear, towels RINSE HOLD 5.5 kg EXTRA RINSE SPIN SPEED White cotton economy... -
Page 23: Special Programmes
Programme chart SPECIAL PROGRAMMES Consumption* Programme Running of Available Programmes Max. load Energy Water Time description programmes options litres h/min. Freshen up For slightly Washing at 30°- RINSE HOLD Cold -30°-40°- soiled fabrics, 40°-60°C SPIN SPEED 60° not for wool 2 rinses 2.5 kg Delicate spin 700... -
Page 24: Maintenance
Maintenance 1. Door seal Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the Check from time to time the door seal and eliminate drawer after cleaning. eventual possible objects that could be trapped in the fold. -
Page 25: Water Inlet Filter
5. Water inlet filter 7. The dangers of freezing If you notice that the machine is taking longer to fill, If the machine is installed in a place where the check that the filter in the water inlet hose is not temperature could drop below 0°C, proceed as blocked. -
Page 26: Something Not Working
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10: problem with the water supply - E20: problem with water draining - E40: door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. -
Page 27: The Door Will Not Open
Problem Possible cause • The door will not open: • The water level is above the bottom edge of the door. • The machine is heating the water. • The drum is turning. The door can only be opened when the relevant light has gone out.