Drain Hose; Electrical Connection - Zanussi ZDT110 User Manual

156997240en.qxp 12/27/2006

Drain hose

- Connect drain hose to the sink. Secure it with the
supplied hose clamp.
- Required height: 30 to 100 cm above bottom of
the dishwasher.
- If you use a drain hose extension the total length
should not be longer than 4 metres. Likewise the
internal diameter of the couplings used for
connections to the waste outlet must be no
smaller than the diameter of the hose provided.

Electrical connection

WARNING!
Safety standards require the appliance to be
earthed. The manufacturer accepts no liability
for failure to observe the above safety
precautions.
Prior to using the appliance for the first time,
ensure that the rated voltage and type of
supply on the rating plate match that of the
supply where the appliance is to be installed.
The fuse rating is also to be found on the rating
plate.
Always plug the mains plug into a correctly
installed shockproof socket.
1:39 PM Page 23
Ensure that the hoses
are not kinked, crushed
or entangled.
Always be sure, that there is no water
leakage from hoses and their connections
after the installation.
WARNING!
Multi-way plugs, connectors and extension
cables must not be used. This could constitute
a fire hazard through overheating.
If necessary, have the domestic wiring system
socket replaced. In case that the electrical
cable has to be replaced, contact your local
Service Force centre.
The plug must be accessible after the
appliance has been installed.
Never unplug the appliance by pulling on the
cable. Always pull the plug.
CAUTION!
23