Glass Assembly; Air Shutter Setting - Heatilator ADI-ZCFB-S Owner's Manual Installation And Operation

1
LOG #5 (SRV340-705):
LOG #6 (SRV740-707):
F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
There are two glass latches on the left side of glass as-
sembly and two glass latches on the right side.
• To release glass assembly, pull latch forward and allow
to retract away from glass assembly.
• Remove glass assembly after all four latches have been
released (see Figure 11.2).
Replacing Glass Assembly
Replace the glass door on the appliance. Fasten the latches
on the glass frame.
5
3
Place log #5 across log #1 and log #3 in the grooved out areas as shown.
6
1
3
Place log #6 across log #1 and log #3 in the grooved out areas as shown.
Heatilator • ADI-ZCFB-S • 2032-910 Rev. i • 6/09
Figure 11.2 Glass Assembly
G. Air Shutter Setting
Optimal fl ame appearance is dependent on the air shutter
setting. Adjustments should be made by a qualified
technician.
Burner
5
6
GLASS
ASSEMBLY
PULL TO
RELEASE
(LEFT SIDE
GLASS LATCH
NG LP
7/16 Full Open
25