Yamaha VX250A Owner's Manual page 86

EMU01560
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise
the lower case and propeller boss may
be damaged.
8 Be sure to use a new cotter pin and
bend
Otherwise, the propeller could come
off during operation and be lost.
1) Apply
Corrosion resistant grease to the pro-
peller shaft.
2) Install the thrust washer and propeller
on the propeller shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut further
to align it with the hole.
602053
4-21
the ends over
Yamaha Marine
E
securely.
grease or