Operation And Important Riding Points; Starting And Warming Up A Cold Engine - Yamaha FZ1 Owner's Manual

WARNING
G Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
ate it in a closed area for any
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.

OPERATION AND IMPORTANT RIDING POINTS

EAU15950
Starting and warming up a
EWA10270 cold engine
In order for the ignition circuit cut-off
familiar
system to enable starting, one of the
following conditions must be met:
G The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
WARNING
G Before starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-16.
G
Never ride with the sidestand
down.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to " ".
CAUTION:
The oil level warning light, coolant
temperature warning light and fuel
level warning light should come on
EAU16210 for a few seconds, then go off. If a
warning light does not go off, have a
Yamaha dealer check the electrical
circuit.
NOTE:
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
EWA10290
Yamaha dealer check the electrical cir-
cuit.
the engine,
to the procedure
NOTE:
If the engine fails to start, release the
start switch, wait a few seconds, and
then try again. Each starting attempt
should be as short as possible to pre-
ECA11430
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
5-1
2. Shift the transmission into the neu-
tral position.
3. Turn the starter (choke) on and
completely close the throttle. (See
page 3-9.)
4. Start the engine by pushing the
start switch.
5