Table of Contents
Advertisement
BASE UNIT OPERATION
STORING A PAUSE IN A DIALING SEQUENCE
To insert a pause while programming a speed dial number, press REDIAL/PAUSE at the
appropriate point in the number sequence. This inserts a 2 second pause. A "P" appears in
the display representing the pause. For longer pauses, press REDIAL/PAUSE two or more
times. Each pause is treated as a stored digit.
INTERCOM
You can Intercom the Handset from the Base Unit (or vice versa).
Press INTERCOM/PAGE on the Base Unit. The Base Unit and Handset will display
** PAGING **.
On the Handset, press INT.COM to respond to the page, or press OFF to terminate the page.
When the Handset initiates the page, the Base Unit will ring twice , and enter Intercom mode.
Both Handset and Base display INTERCOM while in active Intercom mode.
Press INTERCOM/PAGE on the Base Unit to terminate Intercom mode.
CALL WAITING CALLER ID (CID)
In the OFF (on-hook) mode, the Base Unit will display CALLER ID data as the call comes in.
In the SPEAKERPHONE (off-hook) mode, the Base Unit will display CALL WAITING
CALLER ID .
A NEW CALL light will flash on the Base Unit to alert you to new CID records. Once the new
caller ID records have been reviewed on the Handset, the NEW CALL light will go out.
NOTE: Caller ID and Call Waiting Caller ID are subscription services, available through
most local phone service providers. You must subscribe to these services to
benefit from the Caller ID features of this phone. Contact your local phone company
for details.
Due to regional incompatibilities, Caller ID information may not be available for every call you
receive. In addition, the calling party may intentionally block their name and phone number
from being sent.
DATA PORT
NOTE: While the Data Port is in use, accidental use of Line 2 by a parallel phone, the VT2931
Handset, or a Call Waiting ID alert may in inerrupt the data transmission.
DATA PORT
Your VT2931 has a Data Port on the left-hand
edge of the Base Unit. This port provides an easy
way to connect your fax machine, laptop com-
puter, modem, or other telephone device for direct
acces to LINE2.
The Data Port only provides access to Line 2, so
you must have an active line connected to the
LINE2 input on the back of the VT2931.
Connect an RJ-11(2-element) phone cord from
the Data Port to you fax, laptop,etc.
18
Advertisement
Table of Contents
