Speed Dialing; Programming Speed Dial Numbers; Storing A Pause In A Dialing Sequence; Intercom - VTech VT 1932 User Manual

BASE UNIT OPERATION

SPEED DIALING

• Press SPEAKERPHONE.
• Press MEM.
Enter Location (0-9).
• Press SPEAKERPHONE to end your
call.
PROGRAMMING
NUMBERS
• Press PROG. The Base will display:
PROGRAM.
• Press MEM. The Base will display :
ENTER 0 TO 9
• Enter desired Location (0-9). The
Base will display: ENTER NAME
• Use the Base dial pad to enter the
letters (16 characters maximum).
The following table lists the characters
found on each key:
KEY CHARACTER
1 1
2 A>B>C>2
3 D>E>F>3
(etc.)
For the complete
DIRECTORY - TO STORE A NAME
AND NUMBER
To enter 2 characters located on the
same key, or, to add a space, use
the VOLUME key.
For example, to enter the name 'DEAN':
• Press 3
• Press VOLUME
• Press 3 twice
• Press 2
• Press 6 twice
• Press PROG when you finish entering
the name. The Base will display :
ENTER NUMBER.
• Enter the telephone number you wish
to store (32 digits maximum).
SPEED DIAL
table, see:
19
• Press PROG. You will hear a
confirmation beep, and the screen will
go blank.
STORING A PAUSE IN A DIALING
SEQUENCE
To insert a pause while programming a
speed dial number, press REDIAL/
PAUSE at the appropriate point in the
number sequence. This
second pause. A "P" appears in the
display representing the pause. For
longer pauses, press REDIAL/PAUSE
two or more times. Each pause is treated
as a stored digit.

INTERCOM

You can Intercom the Handset from the
Base Unit (or vice versa).
Press INTERCOM/PAGE on the Base
Unit. The Base Unit and Handset will
display ** PAGING **.
On the Handset, press INT.COM to
respond to the page, or press OFF to
terminate the page.
When the Handset initiates the page, the
Base Unit will ring twice , and enter
Intercom mode. Both Handset and Base
display INTERCOM while in active
Intercom mode.
Press INTERCOM/PAGE on the Base
Unit to terminate Intercom mode.

CALL WAITING CALLER ID (CID)

In the OFF (on-hook) mode, the Base
Unit will display CALLER ID data as the
call comes in.
In the SPEAKERPHONE (off-hook) mode,
the Base Unit will display CALL WAITING
CALLER ID .
inserts a 2