End Of The Programme; Start Of The Programme; Standby Mode; Interrupting A Programme - Zanussi ZWP 580 User Manual

• To cancel the delayed start and start the cycle
immediately, press "Start/Pause"
"Delay start" . Press "Start/Pause"
start the cycle.
• To change the timer delay period, you must go
through the "Off" position and reprogram
your cycle.
WARNING !
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the "Start/Pause"
pushbutton. After closing the lid again, press the
"Start/Pause" pushbutton.

Start of the programme

Press the "Start/Pause"
pushbutton to start the cycle ;
the corresponding light will
come on green.
It is normal for the programme
selector to remain stationary during the cycle.
The light corresponding to the
current cycle is illuminated.
: Prewash + Wash
: Rinse + Spin
: End of cycle

Interrupting a programme

Adding washing during the first 10 minutes
Press the "Start/Pause"
responding light will flash green while the
appliance is paused. The lid can only be opened
around 2 minutes after the washing machine has
come to a stop. Press the "Start/Pause"
hbutton again to continue the programme.
Modifying the programme in progress
and then
Before making any changes to the current pro-
to
gramme, you need to pause the washing
machine by pressing the "Start/Pause"
button. If the modification is not possible, the
"Start/Pause"
few seconds. If you still decide to change the
programme, you must cancel the current pro-
gramme (see below).
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the "Off"

End of the programme

The washing machine stops automatically ; the
"Start/Pause"
light
around 2 minutes after the washing machine has
come to a stop.
Turn the programme selector to the "Off"
tion.
Remove washing.
Unplug and close water inlet tap.
We recommend leaving the lid and drum open
after use to ventilate the water tank.

Standby mode

If the appliance is on but no commands are
selected for 10 min before or after a cycle, it
pushbutton : the cor-
goes into standby mode. All the lights go out and
"Start/Pause"
To exit standby mode, simply press any pushbut-
ton or turn the programme selector.
pus-
pushbutton flashes red for a
pushbutton goes out and the
comes on. The lid can only be opened
WARNING !
flashes slowly.
push-
position.
posi-
11