Operating Sequence - Zanussi ZP 3796 Instruction Booklet

Operating Sequence

1 Check that the filters are clean
(see cleaning instructions)
2 Check that there is salt and rinse aid
3 Load the dishes
Remove larger scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
Ensure that the spray arms can rotate freely.
4 Measure out detergent
Pour the required amount of detergent into the dis-
penser according to the indications in the Washing
Programmes chart and close the lid.
Close the dishwasher door.
5 Select and start the programme
Insert the plug into the wall socket.
Open the water tap.
Depress the ON/OFF pushbutton
illuminate .
Depress the NO DRYING pushbutton if you wish to
dispense with the final hot rinse and subsequent dry-
ing operation.
Depress the button which corresponds to the pro-
gramme you wish to select. Keep it pressed for about
1-2 seconds; the programme starts.
If you wish to interrupt the wash at any time press but-
ton again.
To restart the machine, depress the same button
again and the programme will continue from the point
where it was interrupted.
6 At the end of the washing programme
The machine will stop and the pilot light remains on
until ON/OFF button
Turn off the water tap.
Open the door and wait a few minutes before re-
moving the dishes; in this way they will be cooler
and drying will be improved.
Empty the lower basket first and then the upper one;
this will avoid water dripping from the upper basket
onto the dishes in the lower one.
Caution
In general it is not advisable to open the door while
the machine is working; if the door is opened howev-
er, a safety device ensures that the machine stops.
If you have to open the door while the machine is
working, always switch off the appliance first by press-
ing the ON/OFF button
7 Cancel the wash programme
To cancel a wash programme in progress or to reset
the dishwasher if a wrong one has been selected,
proceed as follows:
Turn the dishwasher on by pressing the ON/OFF but-
ton.
Simultaneously depress the QUICK WASH
RINSE AND HOLD
After a few seconds the dishwasher will drain the
water and will be ready for a new washing programme.
; the pilot light will
PSO14GB
28
is depressed.
.
programme buttons.
and