Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDT41
Summary of Contents for Zanussi ZDT41
- Page 1 User manual Dishwasher ZDT41...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Setting and starting a washing programme _ _ _ _ 10 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... -
Page 3: Control Panel
• Do not change the specifications or modify this prod- Contact your local Service Force Centre. uct. Risk of injury and damage to the appliance. • Do not drill into the sides of the appliance to prevent • Do not use the appliance: damage to hydraulic and electrical components. -
Page 4: Washing Programmes
Setting mode The activation of the audible signals is set at the factory. Do these steps to deactivate the audible signals: The appliance is in setting mode when all the programme 1. Switch on the appliance. indicator lights are off and the end indicator light flashes. The appliance must be in setting mode for these opera- 2. -
Page 5: Use Of The Appliance
Programme Degree of soil Type of load Programme description 1 cold rinse (to avoid food scraps from stick- Partial load (to be ing). completed later in This programme does not require the use of the day) detergent). 1) This is the perfect daily programme to clean a not fully load. Ideal for a family of 4 persons who only want to load breakfast and dinner crockery and cutlery. -
Page 6: Use Of Dishwasher Salt
Water hardness Water hardness setting °dH °TH mmol/l Clarke manually electronically 51 - 70 91 - 125 9,1 - 12,5 64 - 88 43 - 50 76 - 90 7,6 - 9,0 53 - 63 37 - 42 65 - 75 6,5 - 7,5 46 - 52 29 - 36... -
Page 7: Use Of Rinse Aid
It is normal that water overflows from the salt con- tainer when you fill it with salt. Make sure that there is no grain of salt outer of the salt compartment. Salt which stays on the tank for a while drills the tank. It is recommended to start a wash- ing programme immediately after you fill the salt con- tainer. -
Page 8: Loading Cutlery And Dishes
Caution! Do not fill the rinse aid dispenser with other products (e.g. dishwasher cleaning agent, liquid detergent). This can cause damage to the appli- ance. Adjusting the dosage of rinse aid The rinse aid dial is set at the factory at position 3. To increase or decrease Fill when the rinse aid in- the dosage refer to 'What... -
Page 9: Use Of Detergent
Warning! Adjust the height before you load the upper basket. Maximum height of the dishes in : upper basket lower basket Upper position 20 cm 31 cm Lower position 24 cm 27 cm Use the cutlery grid. If the dimensions of the cutlery prevent use of the cutlery grid, remove it. -
Page 10: Setting And Starting A Washing Programme
• other cleaning agents. Do these steps to use detergent tablets: 1. Make sure that the detergent tablets are applicable for your water hardness. Refer to the instructions from the manufacturer. 2. Set the lowest levels of water hardness and rinse aid dosage. -
Page 11: Care And Cleaning
2. Release the programme selection/cancel button to • The audible signals for the end of the programme op- cancel the washing programme. erate. At this time you can do these steps: 1. Open the door. 1. Switch off the appliance. –... -
Page 12: What To Do If
Frost precautions Important! Do not remove the spray arms. Caution! Do not install the appliance where the If the holes in the spray arms become clogged, remove temperature is below 0 °C. The manufacturer is not remaining parts of soil with a cocktail stick. responsible for damage because of frost. -
Page 13: Technical Data
The cleaning results are not satisfactory The dishes are not clean • The selected washing programme is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces. • Spray arms do not turn freely because of incorrect arrangement of the load. •... -
Page 14: Installation
Warning! To discard the appliance, follow the • Discard the door catch. This prevents the children to procedure: close themselves inside the appliance and endanger their lives. • Pull the mains plug out of the socket. • Cut off the mains cable and mains plug and discard them. -
Page 15: Electrical Connection
The internal diameter must not be smaller than the diam- eter of the hose. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). If you do not remove the membrane, remaining food can cause a block- age in the drain hose spigot. - Page 16 To buy accessories, consumables and spare parts at our online shop please visit: www.zanussi.co.uk www.zanussi.com...