Operating Sequence - Zanussi ZWF 10020W User Manual

126.2936.29...ZWF10020W.qxd

Operating sequence

as much as possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked
If required, pour fabric softener into the
compartment marked
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
3. Select the required programme
The green Start/Pause light starts to flash.
The selector dial can be turned either
clockwise or anticlockwise.
12
10/4/08 18:01 Página 12
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
.
(the amount used must
The selector dial is
divided into following
sections:
Cottons,
●
Synthetics,
●
Delicates,
●
Special
●
Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red Start/Pause pilot light will
flash 3 times to indicate a wrong selection. The
machine will not perform the new selected
programme.
4. Select the required temperature
Turn the temperature
selector dial to select
the washing
temperature. Maximum
temperatures are 90°C
for cottons, 60°-50°C
for synthetic fabrics,
40°C for delicate fabrics, wool and fabrics to
be hand-washed.
By selecting position (Cold) the machine will
wash with cold water. To be used for extremely
delicate items, such as curtains.
IMPORTANT!
If you choose an incorrect temperature with
some program, the red Start/Pause pilot light
will flash 3 times.
5. Select the spin speed or Night Cycle or
Rinse Hold option
Press the Spin button
repeatedly to change
the spin speed, if you
want your laundry to
be spun at a speed
different from the one
proposed by the
appliance.