Table of Contents
Advertisement
2. Pinch the drawer gently and pull until it is fully opened.
3. Lay the CD/DVD, label side up, in the drawer.
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the
CD/DVD at an angle when you place it in the tray. After seating the
CD/DVD, however, make sure it lies flat, as shown in next figure.
1. Do not touch the laser lens. Doing so could cause misalignment.
2. Do not keep foreign matter from entering the drive. Check the back
edge of the tray to make sure it carries no debris before closing the
drive.
4. Press gently at the center of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush
with the spindle base.
Portégé A100
Manual release with the eject hole
Pulling the drawer open
Operating Basics
4-4
Advertisement
Table of Contents
