Table of Contents
Advertisement
A CONNECT display is
quickly replaced by
NO CARRIER
Character display
becomes garbled
during a
communication
You cannot receive an
incoming call
Standby/Hibernation
Problem
The system will
not enter Standby/
Hibernation
Portégé A100
Check the error control setting in your
communications application.
You can also use the AT\N command.
In data transmission, make sure the parity bit
and stop bit settings correspond with those of
the remote computer.
Check the flow control and communication
protocol.
Check the rings before auto answer setting in
your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Procedure
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Troubleshooting
9-14
Advertisement
Table of Contents
