Fujitsu STYLISTIC Q572 User Manual page 60

Problem
You turn on your Tablet PC
and nothing seems to
happen.
(continued)
Your STYLISTIC Tablet PC
turns off all by itself.
Your Tablet PC will not work
on battery alone.
Possible Cause
System is at a critical thermal
limit.
AC power adapter is not
plugged in properly.
The power adapter has no
power from the AC or airline
outlet.
The power adapter is faulty.
The power management
parameters are set for auto
timeouts which are too short for
your operating needs.
Your power adapter has failed
or lost its power source.
You ignored a low battery alarm
until the battery entered Dead
Battery Suspend mode.
You have a battery failure.
The installed battery is dead.
No battery is installed.
Battery is improperly installed.
Your installed battery is faulty.
Possible Solutions
To avoid damage to heat-sensitive components, the system enters sleep mode when
it gets too hot. System operation cannot be resumed until the Tablet PC cools off to a
tolerable temperature. Move the Tablet PC to a cooler location.
Verify that your adapter is connected correctly. See "Power Sources" on page 37.
Move the AC cord to a different outlet, or check for a line switch or tripped circuit
breaker. If you are using an auto/airline adapter in a car be sure the ignition switch
is in the On or Accessories position.
Try a different power adapter.
Move the mouse to restore operation. If that fails, push Power/Suspend/Resume
switch. Check your power management settings, or close your applications and go to
Power Options located in the Control Panel to adjust timeouts to better suit your
needs.
Make sure the adapter is plugged in and the outlet has power.
Install a power adapter, then push the Power/Suspend/Resume switch. See "Power
Sources" on page 37.
Verify the condition of the battery using the Status Indicator panel. If the battery is
shorted, replace or remove it. See "Status Indicator Panel" on page 22.
Replace the battery with a charged one or use an adapter.
Install a charged battery.
Verify that the battery is properly connected by re-installing it.
Verify the condition of the battery using the Status Indicator panel and replace or
remove any batteries that are shorted. See "Status Indicator Panel" on page 22.
59 - Troubleshooting