Switching On The Refrigerator And Selecting The Temperature - Siemens Refrigerator-freezer Operating Instructions Manual

2.2 Switch on and selecting the temperature
How it works
The fully automatic NO FROST system
ensures that ice dose from inside the
freezer section. There is no longer any
need for defrosting
1 The food is cooled down by a flow of cold air.
2 The evaporator in the NO FROST system
cools the air inside the appliance. The cold air
is circulated by a fan. The moisture in the air
condenses on the evaporator which is
defrosted fully automatically whenever
necessary.
The thawed water is directed to the
refrigerating unit where it evaporates. The
freezer section and the frozen food inside are
kept free from ice.
How to operate when initially
switch on the refrigerator
1 When switch on the refrigerator for the first
time at room temperature (25°C for
instance), the indicator will display the
temperature (this temperature should be the
same as the current room temperature at this
time) of freezer in flash and alarm mode will
initialize.
2 Then press "alarm" button 5 and switch off
the alarm. Press "memory" button 6 then the
indicated temperature could drop as the
freezer temperature drops. If you do not press
"memory" button 6 the indicator will always
display in flashing the initial temperature
( 25°C ), regardless of any change of
temperature in the refrigerator.
3 When the temperature of the freezer drops
to -17°C (it takes about 3 hours and the
compressor may still be working), the
indicator will stop flashing and now the
display is in normal state.
4 Setting freezer temperature
Normally the screen displays the temperature of
1)
freezer.
When the button 2 is pressed continuously, the
2)
temperature will drop 1°C per time till -26°C, then
turn back to -18°C and drop again to reach the
temperature you need.
It is suggested that the freezer temperature
3)
be set around -18°C to -20°C.
5 Setting cooler temperature Figure
Press cooler temperature display button 1
1)
and the screen displays a cooler temperature
which can last only 5 seconds.
The cooler temperature is adjusted by the
2)
turning knob of the damper thermostate on
the rear panel. The temperature in the
compartment drops from position
The turning knob of the damper thermostate
can be set at any position according to the
needs of the customer.
Temperature adjustment during
2
Figure
operation
1 The temperature of the freezer may
sometimes appear too high as indicated and
even alarm occurs. This is either because a
large amount of food is stored in the
refrigerator or freezer door is opened
frequently. Normally it will go back to natural
status within 24 hours.
2 In order to keep food fresh and to save cost,
the setting of temperature in freezer should
be from -18°C to -20°C under a normal room
temperature. Frequent changes should be
avoided once the setting is done.
3 In summer when there is a higher room
temperature the damper thermostate of
cooler could be turned to position
winter when there is a lower room
temperature the damper thermostate of
cooler could be turned to position
4 Please make sure the temperature sensor is
not covered by or has contact with other
objects. It's better to keep a distance
between 5cm to 8cm to avoid any influence
to the temperature display in cooler.
Page 9
GB
1
to
. In
.
2006.7.18, 6:14 PM
.
9