Installation Of The Su-1 - Vertex Standard Pilot VXA-210 Operating Manual

1. Make sure that the transceiver is off. Remove
the hard or soft case, if used.
2. Remove the two screws affixing the belt clip and
remove the belt clip, then remove the battery pack.
3. Locate the connector for the SU-1 under the
"Caution" label in the battery compartment on
the back of the radio, just carefully peel off the
"Caution" label.
4. Remove the small Rubber Cushion from the
"Caution" label. Keep this Rubber Cushion for
future use, because this Rubber Cushion must
be replaced on the connector board of the trans-
ceiver if you remove the SU-1 from the trans-
ceiver. We recommend that this Rubber Cushion
be put on the bottom of the SU-1.
VERTEX STANDARD CO., LTD. MADE IN JAPAN
FCC ID:K66VXA-200
ÛÛÛÛÛÛ
CANADA: ÛÛÛÛÛÛÛÛÛ
4909969000000
SER NO. 00000000
CAUTION
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
Peel off the CAUTION Label
VXA-210 P O
ILOT PERATING
I
NSTALLATION OF THE
5. Align the connector on the SU-1 with the
6. Affix the "Caution" label, and replace the bat-
7. Installation is now complete.
VERTEX STANDARD CO., LTD. MADE IN JAPAN
FCC ID:K66VXA-200
ÛÛÛÛÛÛ
CANADA: ÛÛÛÛÛÛÛÛÛ
4909969000000
SER NO. 00000000
Connector
M
ANUAL
SU-1
transceiver's connector and gently press the unit
into place.
tery and the belt clip.
Important Note
The Barometric pressure/Altitude feature of
the optional SU-1 are designed to be supple-
mental aids for the information of the user, and
are not intended to be a substitute for accu-
rate, calibrated Barometer or Altimeter devices
used for navigation critical to personal safety.
VERTEX STANDARD CO., LTD. MADE IN JAPAN
FCC ID:K66VXA-200
ÛÛÛÛÛÛ
CANADA: ÛÛÛÛÛÛÛÛÛ
4909969000000
SER NO. 00000000
Press the SU-1 Affix the CAUTION Label
VERTEX STANDARD CO., LTD. MADE IN JAPAN
FCC ID:K66VXA-200
ÛÛÛÛÛÛ
CANADA: ÛÛÛÛÛÛÛÛÛ
4909969000000
SER NO. 00000000
CAUTION
Device restricted to occupational use to
satisfy FCC RF exposure compliance.
See owner's manual for specific operat-
ing requirement.
45