Battery Charging - Vertex Standard Pilot VXA-210 Operating Manual

Battery Charging

It is necessary to fully charge the Ni-Cd battery be-
fore its first use. Follow these procedures:
¦ Install the supplied FNB-64 Ni-Cd battery pack
onto the transceiver. Ensure that the transceiver
is switched off.
¦ Plug the NC-77 into the AC line outlet.
¦ Insert the transceiver and battery pack into the
NC-77; the antenna jack should be at the left
side when viewing the charger from the front.
¦ If the transceiver and battery pack are inserted
correctly, the RED indicator will glow. A fully-
discharged pack will be charged completely in
10 hours.
Important Notes:
r The NC-77 is not designed to power the trans-
ceiver for operation (reception or transmission).
r Do not leave the charger connected to the trans-
ceiver for continuous periods in excess of 24
hours. Long term overcharging can degrade the
Ni-Cd battery pack and significantly shorten its
useful life.
r If using a charger other than the NC-77, or if
using a battery pack other than the FNB-64, fol-
10
B Y B
EFORE OU EGIN
low the appropriate instructions provided with
the charger/battery. Contact your Dealer if you
have any doubts about the appropriateness of the
particular charger or battery pack you intend to
use.
VXA-210 P
1 2 3
4 5 6
7 8 9
0
MW F
VXA-210/NC-77
O M
ILOT PERATING ANUAL