Zanussi ZKT 651 DX Installation And Operating Instructions Manual page 21

Problem
flashes
is lit
and number are displayed Electronics fault
and minus are displayed
If you are unable to remedy the problem by following the above sug-
gestions, please contact your dealer or the Customer Care Depart-
ment.
1
Warning! Repairs to the appliance are only to be carried out by qualified
service engineers. Considerable danger to the user may result from improp-
er repairs.
3
If the appliance has been wrongly operated, the visit from the customer
service technician or dealer may not take place free of charge, even during
the warranty period.
Possible cause
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom
of the cookware is too small
for the cooking zone
Overheating protection for
the cooking zone has been
triggered
Safety cut-out has been trig-
gered
Light rays that are too strong
on the control panel, for ex-
ample bright sunlight
Remedy
Use suitable cookware
Place cookware on the cook-
ing zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance
from the electrical supply for
a few minutes (Take the fuse
out of the house's wiring sys-
tem)
If after switching on again,
is displayed again, call the
customer service department
Briefly shade the control pan-
el, for example with the hand
Acoustic signal sounds, ap-
pliance switches itself off
Switch appliance on (again)
45