3. Press Func +
searches, starting from the frequency you
entered in Step 2.
If you enter a frequency that is out of range, the
scanner sounds an error tone and Error appears.
Press Func +
ward or Func +
upward. Frequencies appear during the search.
Notes:
•
You can set the delay function on or off during
the search or while the search stops.
•
You can skip a frequency when the search stops.
After the search skip frequency is set, the scan-
ner starts direct search again.
Direct Entry Search Hold Mode
To stop searching during direct entry search, press Hold.
Hold appears. In this mode, pressing Func +
changes the search direction downward and press-
ing Func +
or
appears depending on the search direction.
Press Func +
step or Func +
down
or
increase or decrease the frequency.
To resume direct search, press Func + Src or Hold.
or
appears on the display, showing the search
direction.
Storing Frequencies Found During Direct
Entry Search into Channel Memory
Follow these steps to store frequencies received
during direct entry search mode or direct entry
search hold mode.
or Func +
to change the search direction down-
to change the search direction
changes the search direction upward.
to decrease the frequency by one
to increase it by one step. Hold
for about 1 second to quickly
40
. The scanner
Special Features