Id Monitor Mode; Id Search Hold And Direct Entry Id In Hold Mode; Programming Scan Lists During Search; Deleting A Stored Id - Uniden UBCT8 Owner's Manual

ID Monitor Mode

By using ID Monitor mode, you can determine which talk groups are the most active without
hearing conversations.
1. Press and hold SRCH
flashing and all active talk group IDs appear on the display every 0.5 seconds.
2. To activate ID search mode, press
Note: Lockout ID also appears on the display.

ID Search Hold and Direct Entry ID in Hold Mode

Just like in Conventional Search, Hold lets you pause ID Search on an interesting
transmission without storing the talkgroup into memory.
If you hear an interesting ID during Search mode,
and want to continue listening to it --
• Press HOLD/RESUME
If you want to listen to a specific ID, while in Hold mode --
• Use the keypad to enter the ID you want and press
the key.
If you want to resume searching --
• Press HOLD/RESUME
Note: ID Hold feature is also applied to ID Scan mode.

Programming Scan Lists During Search

To select a Scan List location and store an ID during Search
mode, follow these steps:
1. When your scanner stops on an ID you want to store, press
HOLD/RESUME.
2. You can change the Scan List memory location by using the
or key. And then press .
3. Press SRCH to return to Trunk Tracking Search mode.

Deleting a Stored ID

To delete a stored ID:
1. Press HOLD/RESUME
2. Select the Scan List location you want to delete by using the
3. Press . 0
4. Then press . E
for 2 seconds until you hear two beeps. Then
SRCH
to stop the search.
to return to Search mode.
E
in the ID Scan mode.
begins
or key.