Control Panel; Lock Mode; To Lock The Controller - Pride Mobility Jazzy Select Owner's Manual

Control Panel

The control panel contains the control buttons and the battery
condition meter. See figure 20.
Horn Button: Activates the horn.
On/Off Button: Turns the controller on and off.
WARNING! Unless faced with an emergency
situation, do not use the on/off key to stop
the chair. This will cause the power chair to
stop abruptly.
WARNING! Always turn the power off when
you are stationary to prevent unexpected
movement.
Speed Dial: Controls the power chair speed.
! Turn the dial clockwise to increase the speed.
! Turn the dial counterclockwise to decrease the speed.
NOTE: We recommend that the first few times you operate
your power chair, you set the speed to the slowest setting
until you become familiar with your new power chair.
Battery Condition Meter: The battery condition meter con-
sists of five LEDs arranged in an arc over the on/off and horn
buttons. See figure 20. The battery condition meter indicates the
status of the electrical system using LED codes. For example, as the battery voltage drops, the number of LEDs reduces
from right to left. When the battery capacity drops to 10% or below, the left red LED will flash.
Battery condition meter codes are as follows:
! ! ! ! ! Left Red LED Flashing: Battery charge is low; Charge the batteries as soon as possible.
! ! ! ! ! Left-to-Right Step of LEDs: The controller is in lock mode; Unlock the controller.
! ! ! ! ! Left-to-Right Ripple of LEDs: The controller is in programming, inhibit, or charging mode.
! ! ! ! ! All LEDs Flashing Quickly: The joystick was not in the center position when the power was switched on, or the
controller system detected a fault; Refer to the Fault Code Table.

Lock Mode

The controller is equipped with a feature that enables you to "lockout" unauthorized users.

To lock the controller:

1. While the power is on, press and hold the on/off button until it beeps (approximately 2 seconds.)
2. Release the on/off button.
3. Move the joystick to the full forward position until it beeps.
4. Move the joystick to the full rearward position until it beeps.
5. Release the joystick. There will be one long beep. The controller system is now locked.
Jazzy Select
V I I . O P E R A T I O N
www.pridemobility.com
Figure 20. GC Joystick Module
33